Effect of catalyzed diesel particulate filter and its catalyst loading on emission characteristics of a non-road diesel engine

In this study, the effects of a diesel oxidation catalyst (DOC) coupled with a catalyzed diesel particulate filter (CDPF) with different catalyst loadings on the power, fuel consumption, gaseous and particulate emissions from a non-road diesel engine were investigated. Results showed that the after-treatment had a negligible effect on the power and fuel consumption. The reduction effect of the DOC on the CO and hydrocarbon (HC) increased with the engine load. Further reductions occurred coupling with the CDPF. Increasing the catalyst loading resulted in a more significant reduction in the HC emissions than CO emissions. The DOC could increase the NO₂ proportion to 37.9%, and more NO₂ was produced when coupled with the CDPF below 250°C; above 250°C, more NO₂ was consumed. The after-treatment could reduce more than 99% of the particle number (PN) and 98% of the particle mass (PM). Further reductions in the PN and PM occurred with a higher CDPF catalyst loading. The DOC had a better reduction effect on the nucleation particles than the accumulation ones, but the trend reversed with the CDPF. The DOC shifted the particle size distribution (PSD) to larger particles with an accumulation particle proportion increasing from 13% to 20%, and the geometric mean diameter (GMD) increased from 18.2 to 26.0 nm. The trend reversed with the CDPF and the accumulation particle proportion declined to less than 10%. A lower catalyst loading on the CDPF led to a higher proportion of nucleation particles and a smaller GMD.     

Oil/Suspended Particulate Material Interactions and Sedimentation

The interactions of physically dispersed oil droplets with suspended particulate material (SPM) can be important for the transport of bulk quantities of spilled crude oil and polycyclic aromatic hydrocarbons (PAH) to subtidal sediments. The literature regarding oil/SPM interactions is reviewed, and results from whole-oil droplet/SPM interaction kinetics and pure-component (Prudhoe Bay crude oil distillate cut) equilibrium partitioning experiments are presented. The effects of oil type, SPM characteristics, and salinity on the interaction rates are examined, and the importance of whole-oil droplet/SPM interactions on particle agglomeration and settling behavior are discussed. Whole-oil droplet/SPM interactions are retarded as oil droplet dispersion into the water column is inhibited by oil viscosity increases due to evaporation weathering and water-in-oil emulsification. Compared to whole oil droplet/SPM interactions, dissolved-component/SPM adsorption is not as significant for transport of individual components to sediments. The information presented in this paper can be used to augment computer-based models designed to predict oil-spill trajectories, oil-weathering behavior, and spilled oil impacts to the marine environment.     

铁合金电炉烟尘治理技术分析

本文在分析了半封闭铁合金电炉产生的烟气、烟尘的特性和各种除尘设备性能的基础上，提出了净化铁合金电炉烟尘的三种技术：袋式除尘、强化湿式除尘和文丘里除尘器。并对袋式除尘工艺和Calvert洗涤器除尘工艺作了介绍，分析了它们的经济技术指标。半封闭铁合金电炉烟尘只能采用布袋除尘器净化，只有那些建在环境空气质量三类区的铁合金电炉，当资金非常紧缺时，才可采用Cavlert洗涤器除尘。     

除湿机的冷凝水化学成分与空气环境质量的关系

本文采用家用除湿机作为空气水溶性物质采样器方法，并验证了该方法作为空气水溶性物质采样嚣的可行性。本文通过空气冷凝水化学成分与空气总悬浮微粒(TSP)可溶性化学成分的对比，得到水汽中大部分阴阳离子的含量只比TSP低1个数量级，而水汽中的微量元素含量与各种碳的浓度不都比TSP低，TSP中一般检测不出亚硝酸根，而水汽中则检出大量亚硝酸根。     

辽河三角洲土壤中石油类含量光谱分析初探

石油类物质对土壤的污染在油田区域内是一个普遍存在的问题。全面了解土壤中石油类物质含量是评价土壤石油污染的前提条件。对土壤石油污染评价的传统方法是在野外实地进行大量土壤采样,然后在试验室内分析石油类物质的含量。文中提出了利用少量野外土壤石油类物质样品,并结合野外光谱测量的方法对土壤中石油类物质进行分析的新方法。该方法应用于辽河三角洲,具有快速、省钱、省时、省力的特点,能对土壤中石油类物质含量进行宏观分析。满足了油田开发对土壤及环境污染评价的需要,并能为制定油田开发管理保护对策提供辅助信息。     

大气颗粒物手工比对监测体系滤膜称量质控技术探讨

健全大气颗粒物手工比对监测体系是"十三五"环境空气自动监测质量管理的一项重点任务,其中颗粒物滤膜的称量直接影响手工监测数据质量。研究调研了国内各级环保部门所属环境监测机构颗粒物滤膜称量工作情况,结合国内外方法标准、技术规范等,重点探讨了称量实验室环境、称量设备、称量影响因素等滤膜称量质控要点,并针对环境管理与监测需求对大气颗粒物手工比对监测滤膜称量质控提出建议。     

利用SPAMS初探盘锦市冬季PM2.5污染特征及来源

利用SPAMS 0515于2015年1月在盘锦市兴隆台空气质量自动监测点位采集PM_(2.5)样品,并分析其污染特征和来源。研究结果表明,盘锦市冬季PM_(2.5)的颗粒类型主要以OC颗粒、富钾颗粒、EC颗粒组成。其中,OC颗粒占比最高,为52.5%;PM_(2.5)污染的主要贡献源为燃煤、生物质燃烧、机动车尾气排放,占比分别为33.2%、25.7%、17.5%,特别是在PM_(2.5)质量浓度较高时段,燃煤和机动车尾气排放对污染的贡献较大。     

柴油机微粒中可溶性有机成分的真空干燥条件

柴油机碳烟颗粒(PM)中可溶性有机组分(SOF)含量是其重要的特性参数,而真空干燥法可方便、高效、可靠地分析颗粒SOF含量,对其干燥条件的探索具有重要的研究意义和应用价值。首先采用模拟的柴油机颗粒,分析不同的干燥条件对模拟SOF(柴油、润滑油)挥发率的影响规律,得出模拟的SOF分析的最佳干燥条件;在此基础上,探索了真实柴油机颗粒SOF分析的最佳干燥条件为:干燥温度220℃、干燥时间3 h、真空度98 kPa,得知SOF组分干燥的难易程度介于柴油和润滑油之间;同时,根据此干燥条件,分析了排气管末端采集的真实碳烟颗粒的SOF含量特性。     

Effects of organic matter on Leymus chinensis germination,growth, and urease activity and available nitrogen in coastal saline soil

ABSTRACT

The present study was carried out to investigate the effect of three organic matters (stalk powder, microbial fertilizer, and manure) on Leymus chinensis germination, growth, and urease activity and available nitrogen (N) in coastal saline soil. The study was conducted in a completely randomized design with eight treatments: J₀V₀Y₀, J₁V₀Y₀, J₀V₁Y₀, J₀V₀Y₁, J₁V₁Y₀, J₁V₀Y₁, J₀V₁Y₁, J₁V₁Y₁. The notations were based on the quantities of each agent added to 1 kg of coastal saline soil: J₀ – no straw powder, J₁ – 0.2 kg straw powder, Y₀ – no manure, Y₁ – 0.3 kg manure, V₀ – no microbial fertilizer, V₁ – 0.2 L microbial fertilizer, each in quantic repeat. L. chinensis was sown as 50 seeds per pot. Results indicated that addition of organic agents exerted a significantly enhanced germination, increase in fresh weight and elevated soil urease activity. Soil available N levels were significantly positively correlated with soil urease activity and fresh weight, but not with germination rate. It is noteworthy that the halophyte L. chinensis showed improved characteristics when grown in coastal saline soil with addition of organic amendments.     

Environmental forensic investigation of the air pollution from a cement manufacturing unit

Abstract

Cement manufacturing is a process that results in the emission of significant quantities of suspended particulate matter (SPM) to the ambient air. An environmental forensic investigation was carried out in the surroundings of a major cement manufacturing unit at a place called Coimbatore in the southern Indian state of Tamil Nadu. The investigation was carried out to identify the contribution of the cement manufacturing unit to the SPM concentration of the surrounding air environment. The sampling points’ selection and sample collection were done following the principles outlined in the INTERPOL Manual for Pollution Crime Forensic Investigation. On-site monitoring of the air samples was carried out using Mini Laser Aerosol Spectrometer (GRIMM, Mini-LAS Model 11R). The instrument was capable of measuring particles ranging from 0.25 to 32 µm and classifying them into 31 size channels. The test results at majority of the monitoring locations were well above the limits specified in the National Ambient Air Quality Standards of India. Microscopic studies of the dust samples were carried out for surface texture and particle shape. The spatial distribution of particles was analysed using geographic information system (GIS) for the visual identification of the extent of the pollution by keeping the cement factory as the focal point. The results from the GIS and microscopic analysis established the role of the cement factory in the particulate matter pollution of its surroundings, specifically in the areas North-West of the factory. The successfully adopted procedure can serve as a guideline for the environmental forensic investigation of similar pollution incidences.